Comment on Once again, I am calling on manufacturers to improve their sealing glues
Bakkoda@sh.itjust.works 1 year ago
I’m not sure how peanut butter is sealed but usually foil lids are sealed with an induction sealer. Cap it’s tightened down (if not potential for a bad deal) and the foil in the cap is pushed tight to the bottle/jar. The metal heats up, melts the plastic and seals.
TrippaSnippa@aussie.zone 1 year ago
This one looks like a pressure seal, which as the name suggests seals by tightening the cap. In my experience from a packing QC standpoint the potential problems with a pressure seal are either the seal not sealing fully because the cap isn’t tightened enough, or the seal getting damaged by the cap being over tightened. This looks like a cheaply made seal wad to me. I dare say the QC department complained about it but management wanted to save a few cents.
fiat_lux@kbin.social 1 year ago
The seal looked to be perfectly vacuumed when I opened it, and the lid wasn't a tight one, so I suspect you're right. But someone else in the thread indicated that this may also be a "feature"? I'm not sure if it's a post hoc rationalisation of shit supply purchase choice or a deliberate design decision or a manufacturing error, but it doesn't matter. I hate it all the same.
Also, thanks for providing me with a proper specific name for these things, and the gift of your experience in all things sealed.